CW308 UFO Target Board
Get probing! The ChipWhisperer CW308 UFO board is the ultimate starting point for side-channel power analysis attacks when combined with a ChipWhisperer Capture solution.
The CW308 puts all the standard requirements onto one board (such as power supplies, oscillators, filters) allowing you to make super-simple target victim boards. A large variety of available target examples provides all levels of architectures for you to test against including 8-bit microcontrollers, 32-bit microcontrollers, and FPGAs.
1.2V, 1.8V, 2.5V, 3.3V, and V-ADJ (1.25V - 3.5V range) power supplies.
Oscillator driver with crystal socket to allow use of most 2 or 3-pin crystals to drive target device or ChipWhisperer.
On-board LC low-pass filter to provide “clean” power supply for resistive shunt measurement.
Diode protection on I/O lines to allow voltage glitch insertion on target with less risk to connected devices.
Soft-start on input power to avoid disconnecting ChipWhisperer-Lite USB when switching power on/off.
Includes 8-bit Atmel XMEGA and 32-bit STM32F3 (Cortex M3) target devices
The CW308 seamlessly connects to the CW1173 and CW1200 capture hardware. The capture hardware provides power, serial communication, clock, shunt resistor monitoring, and power and voltage fault injection capability.
No External Programmer Needed
Select targets (including the AVR, XMEGA, and STM32Fx) can be programmed from the ChipWhisperer, avoiding the need for an external programmer.
Stand alone usage is possible by connecting the SMA measurement port to an oscilloscope input, recommended with the SMA to BNC cable (available option). The CW308T targets implement the Simple-Serial protocol (seehttps://rtfm.newae.com/) and will require a suitable 3.3V serial interface to send and receive data. External programmers will be needed for all targets.
Stand Alone Usage
GLOBAL AUTHORIZED DISTRIBUTOR
#1 purchase method
FREE INTERNATIONAL SHIPPING
Outside the USA
CUSTOMS & TAXES